Arduino Nano Hata

Katılım
18 Eki 2019
Mesajlar
2
Puanları
1
Yaş
24
Arduino:1.8.9 (Windows Store 1.8.21.0) (Windows 10), Kart:"Arduino Nano, ATmega328P"

Çalışmanız programın 3706 bayt (12 %) saklama alanını kullandı. Maksimum 30720 bayt.
Global değişkenler belleğin 228 byte kadarını (11%) kullanıyor. Yerel değişkenler için 1820 byte yer kalıyor. En fazla 2048 byte kullanılabilir.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x0c
Karta yüklenirken sorun oluştu. Tavsiyeler için http://www.arduino.cc/en/Guide/Troubleshooting#upload adresine göz atabilirsiniz.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x0c
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x0c

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.


Yeni Arduino Nano aldım ilk defa taktım program atarken bu sorunla karşılaştım
Klon için kurulum yapmak mı gerekiyor. Port değiştirdim. Ayarlardan Uno dan Nano ya aldım.
 
Kart görüntüsü atabilirmisiniz ch340 cipli olabilir sürücü driver yüklemek gerekiyor onda birde nano seçli olmalı kart ayarlarından başka bir detay yok benim aldım ilk klonda da olmuşdu bu şekilde çözmüşdüm
 
RX tx birşey bağlı değil değil mi ? Yoksa ch340 driverini kurmanız gerekir yokarda söylendiği gibi
 
mega 328p den 328p oldboot a aldım düzeldi
 

Forum istatistikleri

Konular
127,969
Mesajlar
913,975
Kullanıcılar
449,614
Son üye
Canipk

Yeni konular

Geri
Üst